Dell XPS 13 (9333)
Installation
Installation largely runs smoothly. See below for potential problems.
Booting the install media
BIOS and USB drives
It is possible to boot a EFI Arch image. However the XPS' BIOS (tested with BIOS version A04 / XPS 13 9333 circa early 2014) will print "operation system not found" [sic] when using a GPT formatted USB drive. Hence a dd-copied bit-for-bit image of the arch dual ISO will not boot. A workaround is to format the USB drive to VFAT with a bootable MBR as described in USB flash installation medium#BIOS and UEFI. This still allows you to boot in EFI mode (just press F12 during boot - you should find that even after disabling all legacy boot options you can select the arch EFI image) and continue with the install.
You may need to use dosfslabel (from dosfstools) to give the USB drive FAT partition a label that is searched for on boot by the arch ISO (e.g. dosfslabel /dev/sdX1 ARCH_201408) in order for the partition to be mounted properly.
Screen corruption
If the screen corrupts, append nomodeset to the kernel parameters. There may be issues with the cord of the external optical drive, possibly specific to the device.
On Haswell editions, you may run into EFISTUB issues on full UEFI boot as detailed in FS#33745. For workarounds, see Unified Extensible Firmware Interface#USB media gets struck with black screen. This problem is intermittent and may also be present after installation, affecting the choice of bootloaders.
Partitioning
On recent Haswell editions, a full new GPT and ESP work correctly with no boot problems. Remember to swap the system into full EFI boot in the 'BIOS'.
On older XPS 13 models there is an MBR with all four partitions already used. Additionally, if you delete any of the partitions, the boot process will break. Therefore, a dual-boot with Windows is impossible on this machine, although only Arch is probably fine. One solution could be booting from a permanent USB installation. However, this has caveats too. See the #BIOS and USB drives.
Post-installation
No sound from headphone out
The kernel modules snd-hda-intel is loaded automatically, but the model auto-detection seems to leave the system with a non-functional headphone out - there is no sound when headphones are inserted although they are detected and the speakers work. Add this file to your modprobe.d directory and restart:
/etc/modprobe.d/alsa-base.conf
options snd-hda-intel model=dell-headset-multi
This is taken from the pre-installed Ubuntu image that comes with the XPS 13 developer edition.
No sound from built-in speakers
The HDMI output is occasionally detected as the default soundcard on the Haswell XPS 13. Since both use snd-hda-intel we need to specify the vid and pid of each card. To do this, run lspci -nn | grep -i audio - the last set of numbers in braces is the vid and pid of each card.
Add this to your alsa-base.conf file in modprobe.d:
/etc/modprobe.d/alsa-base.conf
# Intel Corporation Haswell-ULT HD Audio Controller options snd-hda-intel index=0 model=auto vid=8086 pid=0a0c # Intel Corporation 8 Series HD Audio Controller options snd-hda-intel index=1 model=auto vid=8086 pid=9c20
Turn off beep sound
The annoying error beep can be turned off by blacklisting its module.
Add this to your nobeep.conf file in modprobe.d:
/etc/modprobe.d/nobeep.conf
# Turn off annoying beep blacklist pcspkr