Pacat

pacat(1) is a simple tool for playing back or capturing raw or encoded audio files on a PulseAudio sound server. It understands all audio file formats supported by libsndfile.

It is also present under the aliases paplay, parecord, parec, and pamon.

Installation

pacat is installed by default with PulseAudio, as part of the libpulse package.

Usage

Please refer to the pacat(1) man page for information on pacat's flags.

paplay is equivalent to pacat --file-format
parecord is equivalent to pacat -r --file-format
parec is equivalent to pacat -r --raw
pamon is equivalent to pacat --raw
When invoking pacat directly, the defaults are equivalent to pacat -p --raw.

To summarize, parecord and parec both record by default, whereas pacat and paplay play back by default. parecord and paplay both deal with encoded audio, whereas parec and pacat work on raw PCM (and thus can be used in pipelines).

Note that a single instance of pacat cannot record and play back at the same time; for that, see #Playing back an audio input.

Select a sink or source

Configuring which sink to play to, or which source to record, can be done using a PulseAudio front-end, or programmatically using the -d option.

To list the available sinks:

$ pactl list sinks short

To list the available sources:

$ pactl list sources short

Removing the short keyword produces detailed output about each sink/source.

There are two ways to refer to a given sink/source: either by name, or by ID. Taking the following source list as an example:

$ pactl list sources short

0	alsa_output.pci-0000_00_1f.3.analog-stereo.monitor	module-alsa-card.c	s16le 2ch 44100Hz	RUNNING
1	alsa_input.pci-0000_00_1f.3.analog-stereo	module-alsa-card.c	s16le 2ch 44100Hz	RUNNING
2	alsa_output.hw_0_7.monitor	module-alsa-sink.c	s16le 2ch 48000Hz	RUNNING
3	rtp.monitor	module-null-sink.c	s16le 2ch 44100Hz	RUNNING

Then the following two lines produce the same result.

$ parecord -d alsa_input.pci-0000_00_1f.3.analog-stereo speech.flac
$ parecord -d 1 speech.flac

Tips and tricks

Low-latency playback

By default, pacat lets the PulseAudio server pick the latency, "usually relatively high for power saving reasons". If this is not desirable, for example for #Playing back an audio input, one can pass the latency (in bytes) or latency-msec option to pacat. For example:

$ pacat -d 0 --latency-msec 1

Note that this usually only needs to be done when playing back, not when recording.

Playing back an audio input

If you are recording an external audio source (for example via a jack male-male cable), you may want to have feedback on what you are recording. This can be done by using parec to capture the input, and piping it into pacat to play it back.

$ parec | pacat

It may be practical to #Select a sink or source directly, for example:

$ parec -d 0 | pacat -d 1

Tip: You may also want to look into #Low-latency playback. However, even with low-latency playback, piping a source into a sink in this way is fairly resource-hungry and introduces noticeable latency. See PulseAudio/Examples#Pipe a source directly into a sink for a better solution.

It is possible to record the sound at the same time by adding tee to the pipeline:

$ parec | tee speech.raw | pacat

Though you may want to launch a separate instance of parec or parecord instead.